Browse by Tags

Adrian, you nailed it. The issue was with that registry setting! I looked at the code samples in the HDK and then looked at the table you mention and set the value based on the bit - not the decimal (hex isn't accepted in the registry editor I was using). I spent some time last night working through...

An update because I've been very quiet of late! I've managed to get the humidity sensor working and I have a reading on the Omnii XT10. My problem is I can't find anyone else out there that has integrated this sensor with the 8MHz 3.3v Arduino before so I'm using code and examples that...

To get people up and running (at least for prototyping) some type of container is mandatory. A new plastic back with some flat surfaces for connectors would speed development and enable partners to showcase their products early on in the development phase. However, I think it would only work for prototypes...

This thread will document progress on the Temperature / Pressure and Humidity sensor module for the Omnii XT10 that I'm currently developing. It was spawned from an initial discussion here about possible modules for the Omnii family. I am planning on purchasing the following sensors for this little...

Coppernic has developped new solutions dedicated to livestock tracking market integrating an Agrident module (ABR105) into the Ikon and the Neo. It allow us to propose LF reader with WWAN for exemple. In fact you can have all the standard options of the Ikon and the Neo with Agrident LF module. Our...