Warning:
The installation of this Compact Flash (CF) radio card must be performed using the appropriate antistatic devices. If unavailable, discharge static from your body by touching a grounded metallic object before opening any covers on the unit.

The WORKABOUT PRO operates with an 802.11b/g Compact Flash (CF) radio card (Model RA2040) which can be easily installed in the unit.


 Important:
The WORKABOUT PRO does not support hot swapping cards. All power sources must be switched off before inserting a card in the unit.
  • To begin, remove the battery pack. If your unit is using AC power, disconnect it.
  • Remove the stylus from the end-cap.
  • Remove the end-cap at the top of the WORKABOUT PRO - unscrew the four Philips head screws from the cap.
Figure 1 The End-Cap And The SW1401 Power Switch

 

 

 

 

 

 

 

 

 

  • Slide the SW1401 switch to the left to shut off internal backup battery power.
  • Carefully slide the radio (with the Psion Teklogix label up) into the CF slot at the top of the hand-held computer until it is fully seated. The black plastic will be flush with the edge of the printed circuit board.
Figure 2 Inserting The 802.11b/g CF Card

 

 

 

 

 

 

  • Gently slide the antenna into the slot at the side of the hand-held (see Figure 3). Ensure that it is firmly seated so that it does not come loose.
Figure 3 Attaching The Antenna

 

 

 

 

 

 

 

  • Once the radio is installed and the antenna inserted, you'll need to attach a CF card stopper (supplied with the radio) to hold the radio in place. Replacement mechanical stops may be ordered separately.
  • Fit the CF stopper over the card, and use the four screws provided to secure the stopper in place. Tighten the screws
    to a torque of 2 lbs-in (2 kgf-cm).


Figure 4 CF Card Stopper Installed
  • Slide the SW1401 switch to the right to turn power back on.
  • Replace the end-cap, and tighten the four Philips screws to a torque of 3 lbs-in (3 kgf-cm).
  • Install the battery, and replace the battery cover.

Connecting To A LAN Using An 802.11b/g Radio

Once the 802.11b/g radio is installed in the WORKABOUT PRO, you'll need to take a few steps to configure the radio. For detailed instructions, please refer to the WORKABOUT PRO Hand-Held Computer User Manual.

Document Declaration WEP128 Encryption Notice

Unable to render {include} Couldn't find a page to include called: Document Declaration WEP128 Encryption Notice

Declaration of Conformity of CF Radio Card Model # RA2040

Unable to render {include} Couldn't find a page to include called: Declaration of Conformity of RA2040 CF Radio

COMPANY HEADQUARTERS

Psion Teklogix Inc.
2100 Meadowvale Boulevard,
Mississauga, Ontario,
Canada L5N 7J9

Tel: +1 905 813 9900
Fax: +1 905 812 6300