Dear All,
What could be the problem if I see a message like this :
b>sndapl: msgQ_Send waited for 16 ms; msgQ_Size=0b>sndapl: msgQ_Send waited for 16 ms; msgQ_Size=0b>sndapl: msgQ_Send waited for 16 ms; msgQ_Size=0b>sndapl: msgQ_Send waited for 16 ms; msgQ_Size=0b>sndapl: msgQ_Send waited for 16 ms; msgQ_Size=0b>sndapl: msgQ_Send waited for 16 ms; msgQ_Size=0b>sndapl: msgQ_Send waited for 16 ms; msgQ_Size=0b>sndapl: msgQ_Send waited for 16 ms; msgQ_Size=0b>sndapl: msgQ_Send waited for 16 ms; msgQ_Size=0
Thanks for your help!
Best regards,
György
Gyorgy, this is a debug message, not an error.
It can not be turn off it is a very low level debug message.
There is no problem with the 9150.
Burt
Hi György
This is a debug level 0 message and only indicates how long our bcm task is waiting to forward data to 9010's queue, and does necessarily not mean there is a problem.
Since there is no timestamp to indicate when the messages appeared these messages may have appeared over a long period of time in which case a single 16ms delay would not add a very long wait to a transaction and should not be considered a problem.
Has any problem been reported?
David
If you have an urgent issue please contact your Regional Technical Support Help Desk
Americas - Asia Pacific - EMEA
Hi David
There was no problem reported I've just checked the system. There was 2-3 messages in every minute.
Thanks for your support!
Hi Gyotgy,
This message look like a debug message, would it be possible to reboot the 9150, monitor it and see if the message reappears.
Regards,
Hi Burt,
Yes it reappears after reboot.
Thanks,
Thanks for your support.
I will leave the 9150 as it is.